Your Cart

Technical support

BATTERY CAPACITY

Light signals for battery capacity more than 25%

Unit:                              
     
Brake light flashes every secund and the USB light green
Lever:                            
Non signal
Trigger:  
Non signal
Hand Control:  Non signal 

Light signals for battery capacity under 25%    

Unit:                              
     
Brake light flashes every secund and the USB light red
Lever:                            
Flashes Red every 10 seconds    
Trigger:  
Flashes Red every 10 seconds 
Hand Control:Flashes Red every 10 seconds

Light signals for Fail-Safe = battery capacity under 15%

Unit:                              
     
1) Brake light flashes every secund and the USB light yellow*
2) Brake light flashes every secund and the USB does not light
Lever:                            
Flashes Red every second
Trigger:  
Flashes Red every second
Hand Control:Flashes Red every second

NOTE*:

  1. If a remote has a battery level under 15%, this remote will activate fail-safe. The remote flashes red every other second and the brake unit(s) flashes with its brake lights and the light beside the usb lights yellow.
  2. If the slave brake unit has a battery level under 15%, only this unit will activate fail-safe. It will flash with the brake lights every other second and the light beside the usb will not light.
  3. If the master brake unit has a battery level under 15%, both this unit and the slave unit will activate fail-safe. It will flash with the brake lights every other second and the light beside the usb will not light.

 

SIGNAL FAILURE

Signal failure more than two seconds between a remote and master brake unit activates fail-safe

Light signals

Unit:                              
     
Brake light flashes every secund and the USB light Blue
Lever:                            
Blue/Green when activation
Trigger:  
Blue when activation
Hand Control:Red when activation

NOTE:

  1. Brake lever in a circuit without other remotes activates fail-safe in case of signal failure
  2. Brake lever in a circuit with other remotes does not activates fail-safe in case of signal failure

Signal failure between master and slave brake units

A Slave Unit who loses contact with the Master unit will not activate fail-safe.

Regain signal after failure

A control that loses contact activates fail-safe. The fail-safe sequence will automatically be deactivated when the remote regain contact with the brake unit.

Remote sleep mode

After 60 minutes of inactivity, both the brake unit (s) and the control (s) go into power save mode (standby). In this mode the system stops sending out signals to save battery.

  1. To “wake” the brake unit(s) push the activation button on (both) unit(s) once.
  2. To “wake” the remote(s) trigger the brake after the unit(s) has been activated.

NOTE: If not all controls are awakened after sleep-mode will fail-safe b

We enable more activity for everyone!

Unique adaptive technology, innovated in Norway.

Wireless brake technology for bikes and more

Rollerskis with wireless brake technology – sports & adaptive

Sitski for any season, terrain and user

The common part in SmartBrake

The brake activator applies brake force to the caliper so that you don’t have to! Read more about the brake unit.

If the handgrip is a challenge, then this will be your solution

Pulling this lever is super soft, and with an easily accessible parking brake function, your next ride will be much smoother. Learn more about the Brake lever.

When independency and additional safety are your priority

Operate the brake and parking wirelessly from 20 meters distance with this small remote. Read more about the hand controller.